Ripping edges would in some cases rip verts on unselected edges. This is now fixed so that we only rip verts from the actually selected edges.
Reviewed By: Brecht
Differential Revision: http://developer.blender.org/D4646
No functional change, this adds LIB definition and args to cmake files.
Without this it's difficult to migrate away from 'BLENDER_SORTED_LIBS'
since there are many platforms/configurations that could break when
changing linking order.
Manually add and enable WITHOUT_SORTED_LIBS to try building
without sorted libs (currently fails since all variables are empty).
This check will eventually be removed.
See T46725.
Some iterations in bevel were over a hash table, which leads
to possibly different results run-to-run, especially when
loop_slide is enabled. Changed those iters to go over all verts
of BMesh, which leads to consistent order run-to-run.
Existing code was not really handling well cases were only edges or
faces were selected (with match select modes).
In those cases, we can assume user want to only affect loop normals of
selected faces/edges, not all lnors of all (indirectly) selected verts.
Also refactored the code a bit to move whole 'loop to edit' selection
process into its own single function.
Broke uv-sphere creation, further it might be a problem
for script authors expecting matching edge order for duplicated content.
Now only apply this when duplicating via the operator.
Convention was not to but after discussion on 918941483f we agree its
best to change the convention.
Names now mostly follow RNA.
Some exceptions:
- Use 'nodetrees' instead of 'nodegroups'
since the struct is called NodeTree.
- Use 'gpencils' instead of 'grease_pencil'
since 'gpencil' is a common abbreviation in the C code.
Other exceptions:
- Leave 'wm' as it's a list of one.
- Leave 'ipo' as is for versioning.
We already have different storages for cddata of verts, edges etc.,
'simply' do the same for the mask flags we use all around Blender code
to request some data, or limit some operation to some layers, etc.
Reason we need this is that some cddata types (like Normals) are
actually shared between verts/polys/loops, and we don’t want to generate
clnors everytime we request vnors!
As a side note, this also does final fix to T59338, which was the
trigger for this patch (need to request computed loop normals for
another mesh than evaluated one).
Reviewers: brecht, campbellbarton, sergey
Differential Revision: https://developer.blender.org/D4407
This triggered an "almost parallel" case in setting the
offset meet points, which is OK but code needed improvement
put the meet point in a more accurate place.
This ia fix for part of the report T61214.
BF-admins agree to remove header information that isn't useful,
to reduce noise.
- BEGIN/END license blocks
Developers should add non license comments as separate comment blocks.
No need for separator text.
- Contributors
This is often invalid, outdated or misleading
especially when splitting files.
It's more useful to git-blame to find out who has developed the code.
See P901 for script to perform these edits.
The subdivision method for getting corner shapes has a fullness
parameter which had been set by eye before. This change uses fullness
as found by offline search process to best match the superellipsoid
octant in the cube corner case (except cube corner case is still handled
by other code). This somewhat improves the look of cube corners with
inner arc miters, however.
Sebastian Parborg
Campbell Barton
Howard Trickey
Ish Bosamiya
Bastien Montagne
Brecht Van Lommel
Pablo Vazquez